![]() ![]() A cheap remote solution could be available instantly instead when someone would like to just skip the track. I have always thought about that because of the fact that taking the mobile out of the pocket and waiting for the Roon App to wake up while looking for the core takes ages. We could even make it run on a Raspberry PI zero with display and knobs and IR receiver so that we end up with a cheap remote control for each zone we’re sitting in. I need some early adopters in order to test such a solution. Use your previously paired remote with no additional software on any machine with flirc or use a name named universal remote. Just walk through our super simple cross platform pairing application, and you're done. Using the same solution we could map different IR-based remote controls mapped using a programmable FLIRC and python code that maps those commands to different Roon zones. Flirc allows you to pair any remote control with your computer or media center. In this video I show you how to make your own USB IR Receiver for your PC / HTPC for less than 4 and how to control basically anything on your PC using any. Volume buttons are ignored by the IR bridge and received by the amplifier while the transport commands from the harmony remote are translated into Roon transport commands right away. What I’m using it for? For me the use case was to integrate a Raspberry PI wearing a DAC hat from Hifiberry into my Harmony setup. The project isn’t in its final state yet but survives restarts and several days uptime without any notice of instability. If the sensor of the device you want to control is not that close, a USB extension cable could be used to bring it into. At the time of writing, the IR transmitter of Flirc USB has a relatively short range of only a few centimeters. The solution can be easily deployed using Ansible to any node running a Linux system providing a systemd interface and supports Python3. Flirc USB contains an IR transmitter that Remote Buddy 2 can use to send commands to other devices, such as TVs. Using a configuration file one will be able to map key codes to Roon transport commands (play, pause, stop, fwd, prev). I’ve started a project in Github that provides the code for a Roon IR bridge that turns received IR events from a FLIRC USB device into commands that are sent to the Roon Core using Roon API The solution can for instance be deployed to a RaspberryPI running Roon Bridge.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |